Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi C467 — Toshiba e-Studio 5560C

Code: C467

Description: Pressure roller thermistor abnormality after entering ready status (temperature abnormality at ready status)
Causes: Pressure roller thermistor Fuser unit Power supply LGC board
Remedy: Power supply • Check if the power voltage is normal.(Is the voltage during the operation ±10% of the rated voltage?) • Connector check (CN403, CN409) Pressure roller thermistor • Sensor check • Install check • Is the pressure roller rear thermistor contacted with the pressure roller surface securely? Fuser unit • Unit check • Connector check • Harness check LGC board • Connector check (CN301, CN306) • Harness check Status counter 1. [0], [8] Power ON. 2. Key in “2002”, then press [START]. 3. Change the current status counter value (08-2002) “5”, “6”, “8”, “18”, “20”, “26”, “28”, “33” or “34” to “0” 4. Turn the power OFF and then back ON. Make sure that the equipment enters the normal ready state. Remarks: The status counter value is set as follows in the following cases. • The error occurred during warming-up: “5” or “6” • The error occurred after the equipment has become ready: “33” • Regardless of the equipment's status (i.e. during warming-up or in ready status), when the temperature detected by the pressure roller thermistor is 210„aC or higher: “8”, “18”, “20”, “26” or “28”. The error occurred during printing: “34”

← Xem tất cả mã lỗi Toshiba e-Studio 5560C

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie