Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E370 — Toshiba e-Studio 600

Code: E370

Description: 3rd drawer transport jam (paper not reaching 3rd drawer / Tandem LCF transport sensor): Paper which has passed the 3rd drawer / Tandem LCF feed sensor does not reach the 3rd drawer / Tandem LCF transport sensor during the feeding at the 3rd drawer.
Remedy: (First page of printing) Is the intermediate transport sensor working? (Perform the input check in the test mode: 03-[FAX]OFF/[1]/[A], OFF/[1]/[C], OFF/[2]/[C], OFF/[3]/[C], OFF/[4]/[C]) ↓ → NO → Open the jam access cover. Remove the paper and check the followings.) 1) Check if the connector of the transport sensor is disconnected. 2) Check if the connector on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short- or opencircuited. 5) Replace the LGC board. YES Is the reversed paper transport clutch working? (Perform the output check in the test mode: 03-210/225/229/230/231) ↓ → NO → 1) Check if the connectors of the transport clutches are disconnected. 2) Check if the connector CN328, 329, 350 on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are opencircuited. 4) Check if the conductor pattern on the LGC board is short- or opencircuited. 5) Replace the transport clutches. 6) Replace the LGC board. YES Check the conditions of the feed roller, separation roller and pickup roller of the drawer in use, and replace them if necessary
(Second page or later of printing) Leading edge of paper not reaching the fuser exit sensor. ↓ → YES . Is there any damage on the paper? (Remove the paper and check the followings.) 1) Check if the paper is skewed, and correct it if it is skewed. 2) Check the paper amount. 3) Check if the paper is not the one with printing on its back side. 4) Check if the width of the side guides of the drawer is too narrow. NO Is the intermediate transport sensor working? (Perform the input check in the test mode: 03-[FAX]OFF/[1]/[A], OFF/[1]/[C], OFF/[2]/[C], OFF/[3]/[C], OFF/[4]/[C]) ↓ → NO . 1) Are paper dusts accumulated on the intermediate transport sensor? 2) Check if the actuator of the sensor is working normally. 3) Check if the harness is not damaged. 4) Check if the connector is disconnected. YES Check the conditions of the feed roller, separation roller and pickup roller of the drawer in use, and replace them if necessary.

← Xem tất cả mã lỗi Toshiba e-Studio 600

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie