Description: Transport delay jam: Paper which has reached the inlet sensor does not pass the inlet sensor.
Remedy: Is there any paper remaining on the transport path in the finisher, saddle stitcher section or main unit? → YES . Remove the paper. NO Is the connector J17 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited? → YES . Connect the connector securely. Replace the harness. NO Is the inlet sensor working properly? (Check the movement of the actuator.) ll → NO . 1) Connect the connector of the sensor securely. 2) Attach the actuator securely if its shaft is out of place. 3) Replace the sensor. YES Replace the finisher controller PC board.