Code: E150
Description: 3rd drawer misfeeding (paper not reaching 3rd drawer / Tandem LCF feed sensor): Paper does not reach the 3rd drawer / Tandem LCF feed sensor during the feeding at the 3rd drawer.
Remedy: Open the feed cover. Is there any paper in front of the 3rd drawer / Tandem LCF feed sensor? → YES → Remove the paper. NO Is the 3rd drawer / Tandem LCF feed sensor working? (Perform the input check in the test mode: 03-[FAX]OFF/[3]/[D]) ↓ → NO → 1) Check if the connector of the 3rd drawer / Tandem LCF feed sensor is disconnected. 2) Check if the connector CN328 on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor patterns on the PFP board and LGC board are short circuited or open circuited. 5) Replace the 3rd drawer / Tandem LCF feed sensor. 6) Replace the LGC board. YES Is the width of the side guides of the 3rd drawer too narrow? Is there any paper skewing? → YES → Fit the width of the original guide to that of the paper. NO Is the 3rd drawer / Tandem LCF feed clutch working? (Perform the output check in the test mode: 03-226) ↓ → NO → 1) Check if the connector of the 3rd drawer / Tandem LCF feed clutch is disconnected. 2) Check if the connector CN328 on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor patterns on the PFP board and LGC board are short circuited or open circuited. 5) Replace the 3rd drawer / Tandem LCF feed clutch. 6) Replace the LGC board. YES Check the 3rd drawer / Tandem LCF feed roller, separation roller and pickup roller. Clean or replace them. * Check if the paper weight is within the specified range.