Description: ADU misfeeding (Paper not reaching the registration sensor): The paper which has passed through ADU does not reach the registration sensor during duplex printing.
Remedy: 1. Open the jam access cover and check if there is any paper in front of the registration sensor. Remove it if there is. * If the error still occurs, check the following. 2. Is the registration sensor working? (Perform the input check:03-[FAX]OFF/[7]/[F]) * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN337 on the LGC board is disconnected from the registration sensor or the harnesses are open circuited. Correct if any. 4. Replace the registration sensor. 5. Replace the LGC board. 6. Is the ADU clutch working? (Perform the output check: 03-222) * If it is working properly, proceed to 10. If not, check 7 to 9 below. 7. Check if the connector CN338 on the LGC board is disconnected from the ADU clutch or the harnesses are open circuited. Correct if any. 8. Replace the ADU clutch. 9. Replace the LGC board. 10.Check the rollers in the ADU. Replace them if they are worn out.