Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E550 — Toshiba e-Studio 6530c

Code: E550

Description: Paper remaining jam on the transport path: The paper is remaining on the transport path when printing is finished (caused by a multiple paper feeding).
Remedy: 1. Open the cover of the unit/area whose picture is flashing on the control panel and remove if there is any paper on the transport path. 2. Is the sensor in the jamming area working? (Perform the input check: Refer to the following table) 3. Check if the connector on the LGC board is disconnected from the corresponding sensor in the jamming area or the harnesses are open circuited. Correct if any. 4. Replace the sensor. 5. Replace the LGC board. Relation between the jamming area and the corresponding sensors/covers (If a jam is occurring in the ADU, LCF or PFP, check the board in each unit.)
Registration area paper feed cover Registration sensor 03-[FAX]OFF/[7]/[F] 1st drawer feed sensor 03-[FAX]ON/[1]/[G] Exit area Fuser cover Exit sensor 03-[FAX]ON/[1]/[B] ADU ADU ADU entrance sensor 03-[FAX]ON/[4]/[B] ADU exit sensor 03-[FAX]ON/[4]/[A] Bypass unit Bypass unit Bypass feed sensor 03-[FAX]ON/[4]/[D] Feeding area (equipment) Paper feed cover 2nd drawer feed sensor 03-[FAX]ON/[1]/[F] 3rd drawer feed sensor 03-[FAX]OFF/[2]/[D] 4th drawer feed sensor 03-[FAX]OFF/[8]/[D] LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[0]/[G] Bridge unit Bridge unit Bridge unit transport sensor-1 (Entrance sensor) 03-[FAX]OFF/[5]/[F] Bridge unit transport sensor-2 (Exit sensor) 03-[FAX]OFF/[5]/[D] Finisher Finisher door Sensors in the finisher

← Xem tất cả mã lỗi Toshiba e-Studio 6530c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie