Description: Punching jam: Punching is not performed properly. [MJ-1103/1104 (when MJ-6102 is installed)]
Remedy: 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Rotate the punch motor (M3) and fix its mechanism if it does not rotate smoothly. 3. Check if the harnesses and the punch HP sensor (S4) are connected properly. Correct if any. 4. Check if the wiring of the hole punch controller PC board (HP board) and the punch motor (M3) is proper. Correct if any. 5. Replace the punch motor (M3). 6. Replace the hole punch control PC board.