Description: Stop jam at the fuser transport sensor: The trailing edge of the paper does not pass the fuser transport sensor after its leading edge has reached this sensor.
Remedy: 1. Open the jam access cover and check if there is any paper on the transport path. Remove it if there is. * If the error still occurs, check the following. 2. Is the fuser transport sensor working? (Perform the input check: 03-[FAX]OFF/[2]/[C]). * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN333 on the LGC board is disconnected from the exit sensor or the harnesses are open circuited. Correct if any. 4. Replace the fuser transport sensor. 5. Replace the LGC board. 6. Check if there is any abnormality on each transport path section of the exit of the fuser unit and the entrance of the bridge unit. Correct if any.