Description: Stapling jam: Stapling is not performed properly. [MJ-1103/1104]
Remedy: 1. Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is. 2. Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? 3. heck if the actuator of the stapler interference sensor (S11) moves smoothly. 4. Check if the connector CN2 on the finisher controller PC board is disconnected from the stapler or the harnesses are open circuited. Correct if any. 5. Check the harnesses in the stapler are disconnected or open circuited. Correct if any. 6. Replace the finisher controller PC board.