Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E020 — Toshiba e-Studio 720

Code: E020

Description: Paper stopping at fuser transport sensor: The trailing edge of paper does not pass the fuser transport sensor after its leading edge has reached the fuser transport sensor.
Remedy: Is the fuser transport sensor working? (Perform the input check in the test mode: 03-[FAX]OFF/[7]/[C]) ↓ → NO → 1) Check if the connector of the fuser transport sensor is disconnected. 2) Check if the connector CN332 on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the fuser transport sensor. 6) Replace the LGC board. YES Is the reverse motor driving? (Perform the output check in the test mode: 03-126) ↓ → NO → 1) Check if the connector of the reverse transport unit is not disconnected. 2) Check if the connector CN335 on the LGC board is not disconnected. 3) Check if the connector pins are not disconnected and the harness is not open circuited. 4) Check if the conductor pattern on the LGC board is not short- or open-circuited. 5) Replace the LGC board YES 1) Check if the separation finger for the fuser unit is working normally. 2) Replace the LGC board

← Xem tất cả mã lỗi Toshiba e-Studio 720

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie