Code: EA30
Description: Power-ON jam: Paper is remaining at the inlet sensor when the power is turned ON.
Remedy: Is there any paper remaining on the transport path in the finisher? → YES . Remove the paper. NO Is any of the connectors J17, J24 and J11 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited? Is the harness connecting the finisher controller PC board and buffer path inlet paper sensor( PI17) open-circuited? Is the harness connecting the finisher controller PC board and buffer path paper sensor (PI14) open circuited? Is the harness connecting the finisher controller PC board and delivery sensor (PI3) open circuited? → YES . Connect the connectors securely. Replace the harnesses. NO Is the inlet sensor working properly? (Check the movement of the actuator.) Is the buffer path inlet paper sensor working properly? (Check the movement of the actuator.) Is the buffer path paper sensor working properly? (Check the movement of the actuator.) Is the delivery sensor working properly? (Check the movement of the actuator.) ll → NO . 1) Connect the connectors of the sensors securely. 2) Attach the actuators securely if their shafts are out of place. 3) Replace the sensors. YES Replace the finisher controller PC board.