Description: LCF side cover opened during printing
Remedy: Is the LCF open? YES Remove the paper if there is any, then close the LCF. NO Is the LCF set sensor working? (Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[1]/[G]) NO 1. Check if the connector of the LCF set sensor is disconnected. 2. Check if either of the connectors J801 to 804 on the LCF board is disconnected. 3. Check if the connector J346 on the LGC board is disconnected. 4. Check if the connector pins are disconnected and the harnesses are open-circuited. 5. Check if the conductor patterns on the LCF board and LGC board are short- or open-circuited. 6. Replace the LCF set sensor. 7. Replace the LCF board. 8. Replace the LGC board. YES 1. Replace the LCF board. 2. Replace the LGC board.