Description: Bypass feed unit cover opened during printing
Remedy: Is the bypass feed unit cover open? YES Remove the paper if there is any, then close the bypass feed unit cover. NO Is the bypass feed unit cover sensor working? (Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[7]/[G]) NO 1. Check if the connector of the bypass feed unit cover sensor is disconnected. 2. Check if the connector J338 on the LGC board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open-circuited. 4. Check if the conductor patterns on the LGC board are short- or open-circuited. 5. Replace the bypass feed unit cover sensor. 6. Replace the LGC board. YES 2. Replace the LGC board.