Code: CB7
Description: Abnormal height sensor
Remedy: [Procedure 1] Is the problem solved by turning the power of the copier OFF and ON? YES END NO Is the wiring between the finisher controller PC board and the height sensor (PS1) correct? YES Correct the wiring. NO Is the voltage between J6-2(+) and J6-4(-) on the finisher controller PC board 5V DC? NO Replace the finisher controller PC board. YES Re-adjust the height sensor. Replace the height sensor if it still causes the problem. [Procedure 2] Is the connector J6 on the finisher controller PC board, J114 of the height sensor (PS1) or relay connector J212 and J213 disconnected? YES Connect the connector(s). NO Is the voltage between J6-2(+) and J6-4(-) on the finisher controller PC board 5V DC? NO Replace the finisher controller PC board. YES Is the wiring between the finisher controller PC board and height sensor correct? YES Correct the wiring. NO Replace the height sensor. [Procedure 3] Is the problem solved by readjusting the DIP switch? YES END NO Is the wiring between the finisher controller PC board and height sensor (PS1) correct? YES Correct the wiring. NO Is the voltage between J6-2(+) and J6-4(-) on the finisher controller PC board 5V DC? NO Replace the finisher controller PC board. YES Replace the height sensor.