Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E01 — Sharp AR810

Code: E01

Description: Leading edge of paper not reaching the fuser exit sensor
Remedy: Open the jam access cover. Is there any paper on the transport path? YES Remove the paper. NO Is the fuser exit sensor working? (Perform the input check in the test mode: 03-[ENERGY SAVER]ON/[6]/[F]) NO 1. Check if the connector of the exit sensor is disconnected. 2. Check if the connector J335 on the LGC board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the exit sensor. 6. Replace the LGC board. YES Is the registration motor working? (Perform the output check in the test mode: 03-108/158) NO 1. Check if the connector of the registration clutch is disconnected. 2. Check if the connector J341 on the LGC board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the registration clutch. 6. Replace the LGC board. YES Check the registration roller. Replace it if it is worn out.

← Xem tất cả mã lỗi Sharp AR810

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie