Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E50 — Sharp AR810

Code: E50

Description: Leading edge of paper not reaching the reverse sensor 2
Remedy: Is there any paper at the reverse section when the exit cover is opened? Remove the paper. Is the reverse sensor 2 working? (Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[2]/[C]) 1. Check if the connector of the reverse sensor 2 is not disconnected. 2. Check if the connector J335 on the LGC board is not disconnected. 3. Check if the connector pins are not disconnected and the harness is not open-circuited. 4. Check if the conductor pattern on the LGC board is not short- or opencircuited. 5. Replace the reverse sensor 2. 6. Replace the LGC board. Is the reverse motor driving? (Perform the output check in the test mode: 03-126) 1. Check if the connector of the reverse drive unit is not disconnected. 2. Check if the connector J335 on the LGC board is not disconnected. 3. Check if the connector pins are not disconnected and the harness is not open-circuited. 4. Check if the conductor pattern on the LGC board is not short- or opencircuited. 5. Replace the LGC board. Check the myler at the reverse section and clean it, or if it is deteriorated, replace it.

← Xem tất cả mã lỗi Sharp AR810

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie