Code: U0 0
Description: Operation control PWB - PCU MAIN PWB communication trouble (OPE/PCU detection)
Causes: "Communication (protocol, data) error"
Remedy: Case 1 Trouble position/cause Bad connection of the signal line between the PCU MAIN PWB and the operation control PWB Remedy (Check) Check the signal line between the PCU MAIN PWB and the operation control PWB. (Repair) Repair or replace the cable and the connector between the PCU MAIN PWB and the operation control PWB. / Power Source-ON Case 2 Trouble position/cause PCU MAIN PWB trouble Remedy (Check) (Repair) Replace the PCU MAIN PWB. / Power Source-ON (After-work) Re-enter setup values and adjustment values. (Install the EEPROM of the defective PCU MAIN PWB to a new PCU MAIN PWB.) Note Case 3 Trouble position/cause Operation control PWB trouble Remedy (Check) (Repair) Operation control PWB replacement / Power Source-ON