Code: E531-0002
Description: - Staple unit failure
- Staple HP sensor failure
- Finisher controller PCB failure
- The staple home position had been left once, but it was not reached again when 400 ms have lapsed since start of staple operation. In addition, the staple home position could not be reached by performing reverse operation for 400 ms.
- Staple HP sensor failure
- Finisher controller PCB failure
- The staple home position had been left once, but it was not reached again when 400 ms have lapsed since start of staple operation. In addition, the staple home position could not be reached by performing reverse operation for 400 ms.
Remedy: - Check the connector of the staple unit. - Replace the staple unit. - Replace the finisher controller PCB.