Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E7-02 — Sharp MXM700U

Code: E7-02

Description: Laser trouble
The BD signal from the LSU is kept OFF or ON. When the polygon motor rotation is started and three successive BDT signals of I/O ASIC are detected after forced lighting of laser.
Causes: The connector to the LSU or the harness in the LSU is disconnected or broken.
The polygon motor does not rotate properly.
The position of the laser home position sensor in the LSU is shifted.
A proper voltage is not supplied to the power line of the laser.
Defective lighting of the laser emitting diode
PCU PWB abnormality
MFP control ASIC PWB abnormality
Remedy: Case 1 Cause The connector to the LSU or the harness in the LSU is disconnected or broken. Check and remedy Check for disconnection of the connector to the LSU. Case 2 Cause The polygon motor does not rotate properly. Check and remedy Check that the polygon motor rotated properly or not. Case 3 Cause The position of the laser home position sensor in the LSU is shifted. Check and remedy Use SIM 61-1 to check the LSU operation. Case 4 Cause A proper voltage is not supplied to the power line of the laser. Check and remedy Replace the LSU unit. Case 5 Cause Defective lighting of the laser emitting diode Check and remedy Check lighting of the laser emitting diode. Case 6 Cause PCU PWB abnormality Check and remedy Replace the MFP control PWB. Case 7 Cause MFP control ASIC PWB abnormality Check and remedy Replace the MFP control PWB.

← Xem tất cả mã lỗi Sharp MXM700U

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie