Code: 04-500
Description: Main Drive (BLDC) Motor Start Fault The Main Drive (BLDC) Motor did not start within the specified time after the ready signal was sent.
Remedy: Start the EDC program. Select the <Menu> button. Using the arrows, scroll to Machine Test, EDC Mode, DC330 Component Control, 100 Motor] to start the motor. The motor rotates. Remove the Right Cover and check the motor connector on the Main PWB. The connector on the Main PWB is connected correctly. Reconnect the motor connector. Remove the Duplex Paper Guide. Check the motor connector. The connector is OK. Reconnect the connector The Imaging Unit Drive coupler may have overloaded. Remove the Print Cartridge and rotate the Imaging Unit coupler. The Imaging Unit coupler rotates freely. Replace the Imaging Unit. The Main Drive Motor or the Main PWB is defective. Perform the following: • Replace the Main Drive Motor. If problem persists, replace the Main PWB.