Causes: 10-700-00 The fuse on the replacement Fuser did not open after installation. 10-710-00 The status of the initialization fuse is unknown after installation.
Remedy: • Check the Fuser connector. • Cycle system power. Check the Fuser connector. The Fuser connector is clean and undamaged. Y↓ N→Remove the Right Cover and reseat CN10 on the MCU Board. The error message is displayed. Y↓ N→Reassemble and perform SCP 6 Final Actions. Cycle system power. The error message is displayed. Y↓ N→Reassemble and perform SCP 6 Final Actions. Replace the MCU Board. Replace the Fuser. The error message is displayed. Y↓ N→Reassemble and perform SCP 6 Final Actions. Replace the MCU Board.