Code: 12-200-00
Description: Jam 1 in Finisher
Causes: Media did not reach the exit sensor and remains inside the Finisher.
Remedy: • Check the Finisher exit sensor and actuator. • Check for obstructions blocking the media path.
NOTE: Remove the Finisher top cover to access the sensor and actuator. Use to access the transport motor. Check the condition of the Finisher feed rollers. The feed rollers are clean and rotate freely. Y↓ N→Clean or repair the affected feed rollers. Select dC330 code 12-805 to test the Finisher exit sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-110 to test the Finisher transport motor, PL 12.40 Item 8. The motor rotates (on/off). Y↓ N→Check the transport motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Finisher top cover to access the sensor and actuator. Use to access the transport motor. Check the condition of the Finisher feed rollers. The feed rollers are clean and rotate freely. Y↓ N→Clean or repair the affected feed rollers. Select dC330 code 12-805 to test the Finisher exit sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-110 to test the Finisher transport motor, PL 12.40 Item 8. The motor rotates (on/off). Y↓ N→Check the transport motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3