Code: 12-500-00
Description: Full Stack
Causes: The Stack Full Sensor indicates the Finisher Stacker Tray is full.
Remedy: • Check the stacker full sensor actuator. • Check for obstructions blocking actuator motion.
NOTE: Remove the Stacker Shield Assembly to access the sensor and actuator. Select dC330 code 12-770 to test the stacker full sensor. The sensor signal changes (high/ low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-885 to test Finisher entrance motor, PL 12.40 Item 10. The motor rotates (on/off). Y↓ N→Check the entrance motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Stacker Shield Assembly to access the sensor and actuator. Select dC330 code 12-770 to test the stacker full sensor. The sensor signal changes (high/ low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-885 to test Finisher entrance motor, PL 12.40 Item 10. The motor rotates (on/off). Y↓ N→Check the entrance motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3