Code: 12-605-00
Description: Staples Low
Causes: The Staple Cartridge is near empty as indicated by the low staple sensor in the Stapler.
Remedy: • Reseat the Staple Cartridge. • Replace the Staple Cartridge.
NOTE: Remove the Stacker Shield Assembly to access the Stapler harness. Cycle system power. The error message is displayed. Y↓ N→Perform SCP 6 Final Actions. Select dC330 code 12-860 to test the low staple sensor. The sensor signal changes (high/ low) as the staple cartridge is installed or removed. Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector and harness. The connector and harness are undamaged. Y↓ N→Replace the sensor or repair the harness. Check Stapler harness connections. The sensor is connected and the harness undamaged. Y↓ N→Repair or reconnect the harness. Replace the Stapler. The error message is displayed. Y↓ N→Reassembly and perform SCP 6 Final Actions. Replace the Finisher Control Board. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Stacker Shield Assembly to access the Stapler harness. Cycle system power. The error message is displayed. Y↓ N→Perform SCP 6 Final Actions. Select dC330 code 12-860 to test the low staple sensor. The sensor signal changes (high/ low) as the staple cartridge is installed or removed. Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector and harness. The connector and harness are undamaged. Y↓ N→Replace the sensor or repair the harness. Check Stapler harness connections. The sensor is connected and the harness undamaged. Y↓ N→Repair or reconnect the harness. Replace the Stapler. The error message is displayed. Y↓ N→Reassembly and perform SCP 6 Final Actions. Replace the Finisher Control Board. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3