Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 12-715-00, 12-716-00 — Xerox Phaser 4600

Code: 12-715-00, 12-716-00

Description: Front Jogger Home Fault
Causes: 12-715-00 The left tamper did not move from home position as indicated by the Left Tamper Home Position Sensor. 12-716-00 The left tamper did not move to home position as indicated by the Left Tamper Home Position Sensor.
Remedy: • Check for obstructions blocking tamper motion. • Cycle system power.
NOTE: Remove the Finisher top cover to access the tamper motor and left cover to access the Left Tamper Home Position Sensor. Select dC330 code 12-815 to test the Left Tamper Home Position Sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor , or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-300 to test the tamper motor, PL 12.35 Item 19. The motor rotates (on/off). Y↓ N→Check the tamper motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3

← Xem tất cả mã lỗi Xerox Phaser 4600

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie