Code: 12-750-00, 12-755-00
Description: Stapler Fault
Causes: 12-750-00 The Stapler failed. 12-750-00 The Stapler jaw did not move to home position as indicated by the staple home sensor.
Remedy: • Open the Stapler Cartridge Door and check for obstructions in the Stapler. • Cycle system power.
NOTE: Remove the Stacker Shield Assembly to access the Stapler harness. Cycle system power. The error message is displayed. Y↓ N→Perform SCP 6 Final Actions. Select dC330 code 12-850 to test the staple home sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector and harness. The connector and harness are undamaged. Y↓ N→Repair the harness. Check Stapler harness connections. The Stapler is connected and the harness undamaged. Y↓ N→Repair or reconnect the harness. Replace the Stapler. The error message is displayed. Y↓ N→Reassembly and perform SCP 6 Final Actions. Replace the Finisher Control Board. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Stacker Shield Assembly to access the Stapler harness. Cycle system power. The error message is displayed. Y↓ N→Perform SCP 6 Final Actions. Select dC330 code 12-850 to test the staple home sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector and harness. The connector and harness are undamaged. Y↓ N→Repair the harness. Check Stapler harness connections. The Stapler is connected and the harness undamaged. Y↓ N→Repair or reconnect the harness. Replace the Stapler. The error message is displayed. Y↓ N→Reassembly and perform SCP 6 Final Actions. Replace the Finisher Control Board. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3