Causes: Tray 1 is not configured with the proper media resources for the current job.
Remedy: • Check media size settings for the tray from the Control Panel. • Load Tray 1 with the media specified in the print job. Cycle system power. The error message is displayed. Y↓ N→Complete. Select dC330 code 07-110. The sensor is operational (high/low). Y↓ N→Replace the Tray 1 No Paper Sensor. Remove the Tray 1 Feeder and inspect the wiring. The harness is undamaged and connected to the MCU Board. Y↓ N→Reconnect or repair the harness. Replace these components in order until the error is corrected. 1. Tray 1 Feeder, PL 8.10 Item 14 2. MCU Board, PL 3.10 Item 3