Code: 04-100-00
Description: Tray 2 Lift Error
Causes: Tray 2 Level Sensor did not change state within 13 seconds of Lift Motor activation.
Remedy: • Remove and replace Tray 2. • Check for obstructions blocking bottom plate movement.
Check Tray bottom plate linkage and sector gear condition. Use an alternate Tray, if available, to test lift operation.The Tray is undamaged. Y↓ N→Replace the Tray. Check Tray 2 pick assembly (PL 8.15) motion. Pick assembly motion is good. Y↓ N→Repair improper pick assembly motion. Check the Lift Gear, PL 4.10. The gear is undamaged and properly installed. Y↓ N→Replace the Lift Gear. Test Lift Motor operation. The Lift Motor rotates. Y↓ N→Remove the Right Cover , reseat CN11 on the MCU Board, then retest. The Lift Motor rotates. Y↓ N→Remove the MCU Board and reseat P/J49 on the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the MCU Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Replace these components in order until the error is corrected. 1. Tray 2. Tray 2 Level Sensor, PL 8.50 Item 25 3. MCU Board
Check Tray bottom plate linkage and sector gear condition. Use an alternate Tray, if available, to test lift operation.The Tray is undamaged. Y↓ N→Replace the Tray. Check Tray 2 pick assembly (PL 8.15) motion. Pick assembly motion is good. Y↓ N→Repair improper pick assembly motion. Check the Lift Gear, PL 4.10. The gear is undamaged and properly installed. Y↓ N→Replace the Lift Gear. Test Lift Motor operation. The Lift Motor rotates. Y↓ N→Remove the Right Cover , reseat CN11 on the MCU Board, then retest. The Lift Motor rotates. Y↓ N→Remove the MCU Board and reseat P/J49 on the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the MCU Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Replace these components in order until the error is corrected. 1. Tray 2. Tray 2 Level Sensor, PL 8.50 Item 25 3. MCU Board