Code: 04-200-00
Description: Tray 3 Lift Error
Causes: Tray 3 Level Sensor did not change state within 13 seconds of Lift Motor activation
Remedy: • Remove and replace Tray 3. • Check for obstructions blocking bottom plate movement
Cycle system power. The error message is displayed. Y↓ N→Complete. Check Tray 3 bottom plate linkage and sector gear condition. Use an alternate Tray to test lift operation.The Tray is undamaged. Y↓ N→Replace the Tray. Check the Pick Assembly (PL 8.20) motion. Pick assembly motion is good. Y↓ N→Repair improper pick assembly motion. Select dC330 code 07-350. The sensor is operational (high/low). Y↓ N→Repair or replace the Level Sensor. Check the Lift Gear, PL 8.35 Item 4. The gear is undamaged and properly installed. Y↓ N→Replace the Lift Gear. Test Lift Motor operation. The Lift Motor rotates. Y↓ N→Remove the Right Cover , reseat CN2 on the Feeder Board, then retest. The Lift Motor rotates. Y↓ N→Check the Feeder Upper Option Harness. The harness is undamaged. Y↓ N→Repair or replace the harness. Replace the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the Feeder Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Remove the IOT and check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the Lower Option Harness. Replace these components in order until the error is corrected. 1. Tray, PL 7.10 Item 23 2. Feeder Board, PL 8.30 Item 7 3. MCU Board, PL 3.10 Item 3
Cycle system power. The error message is displayed. Y↓ N→Complete. Check Tray 3 bottom plate linkage and sector gear condition. Use an alternate Tray to test lift operation.The Tray is undamaged. Y↓ N→Replace the Tray. Check the Pick Assembly (PL 8.20) motion. Pick assembly motion is good. Y↓ N→Repair improper pick assembly motion. Select dC330 code 07-350. The sensor is operational (high/low). Y↓ N→Repair or replace the Level Sensor. Check the Lift Gear, PL 8.35 Item 4. The gear is undamaged and properly installed. Y↓ N→Replace the Lift Gear. Test Lift Motor operation. The Lift Motor rotates. Y↓ N→Remove the Right Cover , reseat CN2 on the Feeder Board, then retest. The Lift Motor rotates. Y↓ N→Check the Feeder Upper Option Harness. The harness is undamaged. Y↓ N→Repair or replace the harness. Replace the Lift Motor, then retest. The Lift Motor rotates. Y↓ N→Replace the Feeder Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Remove the IOT and check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the Lower Option Harness. Replace these components in order until the error is corrected. 1. Tray, PL 7.10 Item 23 2. Feeder Board, PL 8.30 Item 7 3. MCU Board, PL 3.10 Item 3