Code: 07-210-00
Description: Paper Empty at Tray 3
Causes: The Tray 3 No Paper indicates the Tray is empty.
Remedy: 1. Add media to the Tray. 2. Check the No Paper Sensor Actuator. 3. Check for obstruction of the Pick mechanism.
Check the Tray 3 No Paper Sensor Actuator. The actuator is undamaged and motion is good. Y↓ N→Repair or replace the Tray 3 No Paper Sensor Actuator. Select dC330 code 07-310 to test the sensor. The sensor signal changes (high/low). Y↓ N→Remove the IOT, from the Feeder and check the Upper Option Harness, PL 8.30 Item 10. The harness is undamaged. Y↓ N→Replace the harness. Check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the IOT Lower Option Harness. Replace the Tray 3 No Paper Sensor , then retest. The sensor signal changes. Y↓ N→Remove the Right Cover and reseat CN3 on the Feeder Board, then retest. The sensor signal changes. Y↓ N→Replace the MCU Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Replace the MCU Board.
Check the Tray 3 No Paper Sensor Actuator. The actuator is undamaged and motion is good. Y↓ N→Repair or replace the Tray 3 No Paper Sensor Actuator. Select dC330 code 07-310 to test the sensor. The sensor signal changes (high/low). Y↓ N→Remove the IOT, from the Feeder and check the Upper Option Harness, PL 8.30 Item 10. The harness is undamaged. Y↓ N→Replace the harness. Check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the IOT Lower Option Harness. Replace the Tray 3 No Paper Sensor , then retest. The sensor signal changes. Y↓ N→Remove the Right Cover and reseat CN3 on the Feeder Board, then retest. The sensor signal changes. Y↓ N→Replace the MCU Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Replace the MCU Board.