Code: 07-710-00
Description: HCF Out of Paper
Causes: The HCF No Paper Sensor indicates the HCF is empty. NOTE: Optional Tray numbering varies by configuration. When testing HCF components, use the dC330 codes appropriate for the HCF’s position. For example, if the configuration is 5 trays and the 5th tray is the HCF, use Tray 5 control codes.
Remedy: • Check the No Paper Sensor Actuator. • Check for obstructions lift plate movement.
Cycle system power. The error message is displayed. Y↓ N→Complete. Check the No Paper Sensor Actuator. The actuator is undamaged and motion is good. Y↓ N→Repair or replace the No Paper Sensor Actuator. Select dC330 code for the No Paper Sensor based on HCF position. The sensor signal changes (high/low). Y↓ N→Replace the No Paper Sensor , then retest. The sensor signal changes. Y↓ N→Remove the IOT and installed Feeders. Check the option harness connections. The harnesses are undamaged. Y↓ N→Replace any damaged harnesses. Check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the Lower Option Harness. Remove the Right Cover, reseat CN3 on the HCF Control Board, then retest. The sensor signal changes. Y↓ N→Replace the HCF Control Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Raise and lower the lower lift plate. The lower lift plate moves up and down smoothly. Y↓ N→Repair or replace damaged components. Check Pick-up Assembly (PL 8.25) motion. Pick assembly motion is good. Y↓ N→Repair improper Pick-up Assembly motion. Replace these components in order until the error is corrected. 1. Pick-up Assembly, PL 8.25 Item 16 2. HCF Control Board, PL 7.25 Item 18 3. MCU Board, PL 3.10 Item 3
Cycle system power. The error message is displayed. Y↓ N→Complete. Check the No Paper Sensor Actuator. The actuator is undamaged and motion is good. Y↓ N→Repair or replace the No Paper Sensor Actuator. Select dC330 code for the No Paper Sensor based on HCF position. The sensor signal changes (high/low). Y↓ N→Replace the No Paper Sensor , then retest. The sensor signal changes. Y↓ N→Remove the IOT and installed Feeders. Check the option harness connections. The harnesses are undamaged. Y↓ N→Replace any damaged harnesses. Check the IOT Lower Option Harness. The harness is undamaged. Y↓ N→Replace the Lower Option Harness. Remove the Right Cover, reseat CN3 on the HCF Control Board, then retest. The sensor signal changes. Y↓ N→Replace the HCF Control Board. Reassemble and perform SCP 6 Final Actions. Reassemble and perform SCP 6 Final Actions. Raise and lower the lower lift plate. The lower lift plate moves up and down smoothly. Y↓ N→Repair or replace damaged components. Check Pick-up Assembly (PL 8.25) motion. Pick assembly motion is good. Y↓ N→Repair improper Pick-up Assembly motion. Replace these components in order until the error is corrected. 1. Pick-up Assembly, PL 8.25 Item 16 2. HCF Control Board, PL 7.25 Item 18 3. MCU Board, PL 3.10 Item 3