Code: 08-500-00
Description: Jam 2 in Fuser Exit
Causes: Media remains in the Fuser exit.
Remedy: • Check the media. • Check for obstructions in the media path. • Check Fuser installation and condition.
Check the Fuser Gear for damage. The gear is undamaged. Y↓ N→Replace the Fuser Gear. Check the Fuser Heat and Pressure rollers. The rollers rotate freely and are clean Y↓ N→Replace Fuser components as needed to restore proper operation: • Heat Roller and Bearings, PL 10.11 Item 12 • Pressure Roller and Bearings, PL 10.11 Item 3 • Fuser Gear, PL 10.11 Item 14 Select dC330 code 10-400 to test the Fuser Drive Assembly. The Fuser Drive Assembly rotates (on/off). Y↓ N→Remove the Right Cover and reseat CN5 on the MCU Board, then retest. The Fuser Drive Assembly rotates. Y↓ N→Replace the Fuser Drive Assembly. Reassemble and perform SCP 6 Final Actions. Refer to WD 8and select dC330 code 10-900 to test the Fuser Release Drive. The Fuser Release Drive rotates (on/off). Y↓ N→Remove the Left Cover and reseat CN1 on the Joint Board, then retest. The Fuser Release Drive rotates. Y↓ N→Replace the Fuser Release Drive. Reassemble and perform SCP 6 Final Actions. Y↓ N→Remove the Right Cover and reseat CN5 on the MCU Board. The exit rollers rotate. Y↓ N→Replace the Exit Drive Assembly. Reassemble and perform SCP 6 Final Actions. Replace these components in order until the error is corrected. 1. Fuser, PL 10.10 Item 1 (110V) PL 10.10 Item 2 (220V) 2. MCU Board, PL 3.10 Item 3
Check the Fuser Gear for damage. The gear is undamaged. Y↓ N→Replace the Fuser Gear. Check the Fuser Heat and Pressure rollers. The rollers rotate freely and are clean Y↓ N→Replace Fuser components as needed to restore proper operation: • Heat Roller and Bearings, PL 10.11 Item 12 • Pressure Roller and Bearings, PL 10.11 Item 3 • Fuser Gear, PL 10.11 Item 14 Select dC330 code 10-400 to test the Fuser Drive Assembly. The Fuser Drive Assembly rotates (on/off). Y↓ N→Remove the Right Cover and reseat CN5 on the MCU Board, then retest. The Fuser Drive Assembly rotates. Y↓ N→Replace the Fuser Drive Assembly. Reassemble and perform SCP 6 Final Actions. Refer to WD 8and select dC330 code 10-900 to test the Fuser Release Drive. The Fuser Release Drive rotates (on/off). Y↓ N→Remove the Left Cover and reseat CN1 on the Joint Board, then retest. The Fuser Release Drive rotates. Y↓ N→Replace the Fuser Release Drive. Reassemble and perform SCP 6 Final Actions. Y↓ N→Remove the Right Cover and reseat CN5 on the MCU Board. The exit rollers rotate. Y↓ N→Replace the Exit Drive Assembly. Reassemble and perform SCP 6 Final Actions. Replace these components in order until the error is corrected. 1. Fuser, PL 10.10 Item 1 (110V) PL 10.10 Item 2 (220V) 2. MCU Board, PL 3.10 Item 3