Code: 12-715-00, 12-716-00
Description: Front Jogger Home Fault
Causes: 12-715-00 The left tamper did not move from home position as indicated by the Left Tamper Home Position Sensor. 12-716-00 The left tamper did not move to home position as indicated by the Left Tamper Home Position Sensor.
Remedy: • Check for obstructions blocking tamper motion. • Cycle system power.
NOTE: Remove the Finisher top cover to access the tamper motor and left cover to access the Left Tamper Home Position Sensor. Select dC330 code 12-815 to test the Left Tamper Home Position Sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor , or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-300 to test the tamper motor, PL 12.35 Item 19. The motor rotates (on/off). Y↓ N→Check the tamper motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Finisher top cover to access the tamper motor and left cover to access the Left Tamper Home Position Sensor. Select dC330 code 12-815 to test the Left Tamper Home Position Sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor , or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-300 to test the tamper motor, PL 12.35 Item 19. The motor rotates (on/off). Y↓ N→Check the tamper motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3