Code: 12-735-00, 12-736-00
Description: Support Finger Home Fault
Causes: 12-735-00 The eject assembly did not move from home position as indicated by the Eject Home Position Sensor. 12-735-00 The Compile Tray eject assembly did not move to home position as indicated by the Eject Home Position Sensor.
Remedy: • Cycle system power. • Check for obstructions blocking eject assembly motion.
NOTE: Remove the Stacker Shield Assembly to access eject assembly components. Select dC330 code 12-825 to test the Eject Home Position Sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor, or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-400 to test the eject motor, PL 12.30 Item 12. The motor rotates (on/ off). Y↓ N→Check the eject motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3
NOTE: Remove the Stacker Shield Assembly to access eject assembly components. Select dC330 code 12-825 to test the Eject Home Position Sensor. The sensor signal changes (high/low). Y↓ N→Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sensor and harness. The sensor is connected and the harness undamaged. Y↓ N→Replace the sensor, or repair the harness. Replace the Finisher Control Board. Select dC330 code 12-400 to test the eject motor, PL 12.30 Item 12. The motor rotates (on/ off). Y↓ N→Check the eject motor connection and harness. Repair or reconnect as necessary. Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged. Y↓ N→Repair the harness. Replace these components in order until the error is corrected. 1. IOT Upper Option Harness, PL 10.30 Item 24 2. MCU Board, PL 3.10 Item 3