Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E3-1, E3-2 — Xerox Phaser 5400

Code: E3-1, E3-2

Description: Jam at A - Fuser Area Jam Paper did not actuate the Fuser Exit Sensor, located behind Door A, within the specified time. • Jam at A - E3-1 Fuser Area Jam • Jam at A - E3-2 Fuser Area Jam
Causes: • Fuser Exit Sensor • Take Away Roller • Engine Control Board • Fuser
Remedy: 1 Check paper position. Open Door A. Does the paper touch the Fuser Exit Sensor? Remove the paper. Go go step 2. 2 Check the Fuser for a paper jam. Open Door A. Is there a paper jam in the Fuser? Go to Step 3. Remove the paper. 3 Check the Fuser installation. Open Door A. Is the Fuser installed correctly? Go to Step 4. Correct the installation. 4 Check the Take Away Roller. Open Door A. Is the Take Away Roller worn or contaminated with paper dust? Go to Step 5. Clean or replace Take Away Roller. 5 Test the Fuser Exit Sensor operation. 1. Open Door A. 2. Run the Service Diagnostic Fuser Exit Sensor test. Does the sensor state change each time paper touches the sensor? Reconnect the connector of the Engine Control Board. Go to Step 6. 6 Check the Fuser Exit Sensor connection. Are P/J125 and P/J410 connected? Go to Step 7. Connect P/J125 and P/J410. 7 Check continuity between the Fuser Exit Sensor and Engine Control Board. Is there continuity on each wire between P/ J125 <=> P/J410? Go to Step 8. Repair the wiring. 8 Check for +5 V to the Fuser Exit Sensor. Is there +5 V across J125-3 (+) <=> ground? Replace the Fuser Exit Sensor. Replace Engine Control Board

← Xem tất cả mã lỗi Xerox Phaser 5400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie