Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E3-6 — Xerox Phaser 5400

Code: E3-6

Description: Jam at A - E3-6 Fuser Area Jam Paper remains at the Fuser Exit Sensor located behind Door A.
Causes: • Fuser Exit Sensor • Engine Control Board
Remedy: 1 Check paper position at Door A. Is paper touching the Fuser Exit Sensor? Remove the paper. Go to Step 2. 2 Test the Fuser Exit Sensor. 1. Open Door A. 2. Run the Service Diagnostics Fuser Exit Sensor test. Does the sensor change state? Replace the Engine Control Board. Go to Step 3. 3 Check the Fuser Exit Sensor connection. Are P/J125 and P/J410 connected? Go to Step 4. Connect the sensor. 4 Check continuity between the Fuser Exit Sensor and Engine Control Board. Is there continuity on each wire between P/ J125 <=> P/J410? Go to Step 5. Repair the wiring. 5 Check for +5 V at the Fuser Exit Sensor. Is there +5 V across the sensor connector’s P/J125-3 <=> ground? Replace the Fuser Exit Sensor. Replace the Engine Control Board.

← Xem tất cả mã lỗi Xerox Phaser 5400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie