Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E4-6 — Xerox Phaser 5400

Code: E4-6

Description: Jam at E - E4-6 Exit 2 Area Jam Paper remains at the Exit 2 Exit Sensor located behind Door E.
Causes: • Exit 2 Exit Sensor • Exit PWB • Engine Control Board • LVPS
Remedy: 1 Check paper position at Door A. Is paper touching the Fuser Exit Sensor? Remove the paper. Go to Step 2. 2 Test the Exit Sensor. Run the Service Diagnostics Exit Sensor test. Does the sensor change state? Replace the Engine Control Board. Go to Step 3. 3 Check the Exit Sensor connection. Are P/J112, P/J606B and P/J434 connected? Go to Step 4. Connect the sensor. 4 Check continuity between the Exit Sensor and Exit PWB. Is there continuity on each wire between P/ J112<=> P/J434? Go to Step 5. Repair the wiring. 5 Check for +5 V at the Exit Sensor. Is there +5 V across the sensor connector’s P/J112-3 <=> ground? Replace the Exit Sensor. Go to Step 6. 6 Check the connection between the Exit PWB and Engine Control Board. Are P/J431 and P/J421 connected? Go to Step 7. Connect P/J431 and P/J421. 7 Check continuity between the Exit PWB and Engine Control Board. Is there continuity on each wire between P/ J431 <=> P/J421? Go to Step 8. Repair the wiring. 8 Check the connection between Exit PWB and LVPS. Are P/J430 and P/J526 connected? Go to Step 9. Connect P/J430 and P/J526. 9 Check continuity between the Exit PWB and LVPS. Is there continuity on each wire between P/ J430 <=> P/J526? Go to Step 10. Repair the wiring. 10 Check for +24 V to the Exit PWB. Is there +24 V across P/J430-1 (+) <=> ground? Replace the Exit PWB. Replace the LVPS.

← Xem tất cả mã lỗi Xerox Phaser 5400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie