Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi U4-9 — Xerox Phaser 5400

Code: U4-9

Description: Fan Failure - U4-9 Fan Defect The Fuser Fan failed.
Causes: • Fuser Fan • Motor Assembly • Engine Control Board
Remedy: 1 Check the Fuser Fan installation. 1. Remove the I/P Board Cover. 2. Remove the Upper Rear Cover. Go to Step 2. Correct the installation. 2 Check if the Fuser Fan rotates. Does the Fan rotate? Go to step 6. Go to step 3. 3 Test the Fuser Fan. Run the Service Diagnostic Fuser Fan test. Does the Fuser Fan operate properly? Go to step 6. Go to step 4. 4 Check the Fuser Fan connection (CN102). Is the Fan connected? Go to Step 5. Connect the Fan. 5 Check continuity between the Fan and Motor Assembly (CN102). Is there continuity on each wire? Go to Step 6. Replace the Fan. 6 Check for +24 V to the Fuser Fan. Is there +24 V across CN102-3(+) <=> ground? Replace the Fan. Replace the Fan. If the error persists, replace the Engine Control Board, then replace the Motor Assembly.

← Xem tất cả mã lỗi Xerox Phaser 5400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie