Code: E3-6
Description: Jam at A - E3-6 Fuser Area Jam Paper remains at the Fuser Exit Sensor located behind Door A.
Causes: • Fuser Exit Sensor • Engine Control Board
Remedy: 1 Check paper position at Door A. Is paper touching the Fuser Exit Sensor? Remove the paper. Go to Step 2. 2 Test the Fuser Exit Sensor. 1. Open Door A. 2. Run the Service Diagnostics Fuser Exit Sensor test. Does the sensor change state? Replace the Engine Control Board. Go to Step 3. 3 Check the Fuser Exit Sensor connection. Are P/J125 and P/J410 connected? Go to Step 4. Connect the sensor. 4 Check continuity between the Fuser Exit Sensor and Engine Control Board. Is there continuity on each wire between P/ J125 <=> P/J410? Go to Step 5. Repair the wiring. 5 Check for +5 V at the Fuser Exit Sensor. Is there +5 V across the sensor connector’s P/J125-3 <=> ground? Replace the Fuser Exit Sensor. Replace the Engine Control Board.