Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi J1-2 — Xerox Phaser 5500

Code: J1-2

Description: Toner Empty - J1-2 Toner Empty The Toner Cartridge is empty.
Causes: • Toner Cartridge • Toner Dispense Assembly • Toner Dispense Motor • Toner CRUM PWB • Engine Control Board
Remedy: 1 Check remaining toner. Does the Toner Cartridge contain sufficient toner? Go to Step 2. Replace the Toner Cartridge. 2 Check the Toner Cartridge installation. Remove the Toner Cartridge and reinstall. Does it operate properly? Problem solved. Go to Step 3. 3 Check the gear of the Toner Dispense Assembly. Does the gear of the Toner Dispense Assembly rotate smoothly? Go to Step 4. Restore proper operation. 4 Check the Toner Dispense Assembly for clogging. Is the tube located at the lower part of the Toner Dispense Assembly clogged? Check the tube. Go to Step 5. 5 Check the Toner CRUM PWB installation. Is the Toner CRUM PWB installed correctly? Go to Step 6. Correct the installation. 6 Check the Toner CRUM PWB connections. Are P127 and P/J419 connected? Go to Step 7. Connect P127 and P/J419. 7 Check continuity between the Toner CRUM PWB and Engine Control Board. 1. Disconnect P/127 and P/J419. 2. Check for continuity at the following: • P127-6 <=> P/J419-6 • P127-5 <=> P/J419-7 • P127-4 <=> P/J419-8 • P127-3 <=> P/J419-9 • P127-2 <=> P/J419-10 • P127-1 <=> Not connected Are these conductive? Go to Step 8. Repair the wiring. 8 Check for +5 V to the Toner CRUM PWB. Is there +5 V across P127-6 (+) <=> ground? Go to Step 9. Replace the Engine Control Board. 9 Test the Toner Dispense Motor. Run the Service Diagnostics Toner Dispense Motor test. Does the motor rotate? Replace the Engine Control Boar. Go to Step 10. 10 Check Toner Dispense Motor connections. Are P/J216 and P/J420 connected? Go to Step 11. Connect P/J216 and P/J420. 11 Check continuity between the Toner Dispense Motor and Engine Control Board. 1. Disconnect P/J420 and P/J216. 2. Check for continuity at the following: • P/J420-1 <=> P/J216-2 • P/J420-2 <=> P/J216-1 Are these conductive? Go to Step 12. Repair the wiring. 12 Check for +24 V to the Toner Dispense Motor. Is there +24 V across P/J216-1 (+) <=> ground? Replace the Toner Dispense Motor. Replace the Engine Control Board.

← Xem tất cả mã lỗi Xerox Phaser 5500

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie