Code: 077-100
Description: Reg On Early Jam Paper stuck in the Registration section (or Main Paper Tray or Bypass Tray section) of the Printer was detected.
Causes: • Registration Sensor, PL2.3.5 • Harn assy rkn sns, PL2.2.25/26 • MCU Board, PL7.2.2
Remedy: • Check the media path for obstructions or debris. • Cycle printer power. • If the problem persists, follow this procedure.
1 Check connectors P/J12 and P/J120 between the MCU Board and the Registration Sensor. Are the connectors secure? Go to step 3. Reconnect the connectors, then go to step 2. 2 Does the error persist? Go to step 3. Complete. 3 Disconnect the MCU Board P/J21 and the Registration Sensor P/J120. Check the harness assy rkn sns for continuity. Is the harness damaged? Go to step 4. Repair the harness. 4 Disconnect the MCU Board P/J12. Is the voltage across ground and P/J12-1 +3.3VDC? Replace the Registration Sensor. Replace the MCU Board.
1 Check connectors P/J12 and P/J120 between the MCU Board and the Registration Sensor. Are the connectors secure? Go to step 3. Reconnect the connectors, then go to step 2. 2 Does the error persist? Go to step 3. Complete. 3 Disconnect the MCU Board P/J21 and the Registration Sensor P/J120. Check the harness assy rkn sns for continuity. Is the harness damaged? Go to step 4. Repair the harness. 4 Disconnect the MCU Board P/J12. Is the voltage across ground and P/J12-1 +3.3VDC? Replace the Registration Sensor. Replace the MCU Board.