Code: 077-108
Description: Exit Off Early Jam The paper passed through the Exit Sensor earlier than the specified time, or did not pass through the Exit Sensor within the specified time.
Causes: • Fuser, PL5.1.1 • MCU Board, PL7.2.2
Remedy: • Check the media path for obstructions or debris. • Cycle printer power. • If the problem persists, follow this procedure.
1 Check P/J18 on the MCU Board. Is P/J18 connected securely. Go to step 3. Reconnect P/J18, then go to step 2. 2 Does the error still occur when printing? Go to step 3. Complete. 3 Replace the Fuser. Warning: Allow the fuser to cool before replacement. Does the error still occur when printing? Replace the MCU Board. Complete.
1 Check P/J18 on the MCU Board. Is P/J18 connected securely. Go to step 3. Reconnect P/J18, then go to step 2. 2 Does the error still occur when printing? Go to step 3. Complete. 3 Replace the Fuser. Warning: Allow the fuser to cool before replacement. Does the error still occur when printing? Replace the MCU Board. Complete.