Code: 077-100
Description: Paper Remain at Regi Paper remain was detected at the Registration section (or Paper Tray/Bypass Tray section) of the printer. Applicable Error
Causes: • Registration Sensor, PL2.3.5 • Harness Assembly RKN SNS, PL2.2.25/26 • MCU Board, PL7.2.2
Remedy: 1. Is the trailing edge of the paper past the registration sensor actuator? Go to step 3. Go to step 5. 2. Enter diagnostic mode and run the Regi Sensor test (see page 2-136). You can also use CE Diag Tool to perform this test (see page 2-110). Lift the Main Paper Tray Chute (PL3.3.3), this pushes on the actuator does the number on the display change each time the Main Paper Tray Chute is lifted? Go to step 3. Replace the Registration Sensor (Phaser 6020 and WorkCentre 6025 MFP, Phaser 6022 and WorkCentre 6027 MFP. 3. Disconnect the MCU Board P/J21 and the Registration Sensor P/J120. Check the Harness Assembly RKN SNS for continuity. Is the harness damaged? Repair the harness. Go to step 4. 4. Disconnect the MCU Board P/J12. Is the voltage across ground and P/J12-1 +3.3VDC? Reconnect the connectors, then go to step 2. 1. SaveNVM to ESS 2. Replace the MCU Board. 3. LoadNVM from ESS 5. Is the ROLL REGI PL 2.3.1 installed correctly and in full contact with ROLL ASSY PINCH REGI PL 2.3.2. Go to step 6. Repair the mechanical issue with ROLL REGI. 6. Enter diagnostic mode and select Engine Diag > Motor Test > Regi Clutch. You can also use the CE Diag Tool to run this test (see "CE Diags Tool"). Does the Registration Clutch function correctly? 1. SaveNVM to ESS 2. Replace the MCU Board. 3. LoadNVM from ESS Replace the Registration Clutch.