Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-372 — Xerox Phaser 6022

Code: 042-372

Description: DEVE Mode Change Failure DEVE Mode Change failure is detected.
Causes: • Feed Solenoid, PL6.1.10 • Switching Sensor • Harness Assembly RKN SNS PL2.2.25/26 • Developer Drive Assembly, PL6.1.6 • MCU Board, PL7.2.2
Remedy: 1. Does the error persist when the power is turned on? Go to step 2. If there is more than only the current error in the fault history, go to step 2. 2. Test the K Mode Solenoid: Enter diagnostic mode and select Engine Diag > Motor Test > K Mode Solenoid You can also use the CE Diag Tool to perform this test (“K Mode Solenoid”). Does the Feed Solenoid function normally? Go to step 4. Go to step 3. 3. Check the P/J10 connector on the MCU Board. Is P/J10 connected correctly? Replace the K Mode Solenoid. Reseat the connector. 4. Does Gear C rotate and engage the drive train when the K mode solenoid releases it? Go to step 5. Replace the developer drive assembly PL6.1.6. 5. Test the color mode sensor in diagnostics. Does the sensor function correctly? Go to step 7. Replace the sensor PL2.3.5 Then go to step 6. 6. Does the sensor function correctly in diagnostics after replacement? Complete. Go to step 7 7. Check the connections between the MCU Board P/J12 and the Feed Sensor P/J122. Are the connections secure? Replace the MCU Board. Reseat the connector.

← Xem tất cả mã lỗi Xerox Phaser 6022

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie