Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-317 — Xerox Phaser 6125

Code: 010-317

Description: Insert Fuser The printer detects that the Fuser is not installed.
Causes: Fuser (PL6.1.1) Fuser Harness Assy (PL6.1.2) MCU Board (PL8.2.13)
Remedy: 1 Reseat the Fuser. Warning: Start the operation after the Fuser has cooled down. Does the error still occur when the power is turned OFF and ON? Go to step 2. Complete 2 Check the connectors for connection Remove the Fuser. Warning: Start the operation after the Fuser has cooled down. Check the connections between the MCU Board and Fuser. Are P/J17 and P/J171 connected correctly? Go to step 4. Reconnect the connector(s) P/ J17 and/or P/ J171 correctly, then go to step 3. 3 Does the error still occur when the power is turned OFF and ON? Go to step 4. Complete 4 Check the Fuser Harness Assy for continuity Remove the Fuser. Warning: Start the operation after the Fuser has cooled down. Disconnect J17 from the MCU Board. Is each cable of J17 <=> P171 continuous? NOTE: P171 is attached to the frame. Go to step 5. Replace the Fuser Harness Assy. 5 Check the resistances of Temp. Sensor in the Fuser Remove the Fuser. Warning: Start the operation after the Fuser has cooled down. Check the resistances across the following pins of the removed Fuser. J171-5 <=> J171-4 J171-6 <=> J171-8 J171-6 <=> J171-7 Can the resistances be measured? (The resistances are 7 k-ohm at 180 degrees C). Replace the MCU Board Replace the Fuser. After replacing the Fuser, be sure to reset the life counter value.

← Xem tất cả mã lỗi Xerox Phaser 6125

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie