Code: 042-325
Description: Motor Error The Main Motor has failed.
Causes: • MCU Board, PL8.2.13 • Main Drive Assembly, PL8.1.2
Remedy: 1 Check the Imaging Unit for correct installation. Is the Imaging Unit seated correctly? Go to step 3. Reseat the Imaging Unit and cycle the power. Go to step 2. 2 Does the error still occur? Go to step 3. Complete. 3 1. Close the Front Cover. 2. Perform the Main Motor test: Service Mode > Engine Diag > Motor Test > Main Motor FULL2. Does the Motor operate properly? Replace the MCU Board. Go to step 4. 4 Check the wiring harness connectors P/J21 and P/J211 between the MCU Board and the Main Drive. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 5. 5 Turn the power Off, then On. Does the error still occur? Go to step 6. Complete. 6 Check the Main Drive for correct installation. Is the Main Drive securely installed? Go to step 8. Reseat the Main Drive. Go to step 7. 7 Does the error still occur? Go to step 8. Complete. 8 Check the Main Drive signal. 1. Disconnect P/J21 on the MCU Board. 2. Are there +24 V across ground <=> J21-2/J21-4 when the Interlock Switch is activated? Replace the Main Drive Assembly. Replace the MCU Board.