Code: -03
Description: Low Density Magenta Cartridge Error The ADC Sensor detects an insufficient amount of Mageneta toner being applied. The following troubleshooting procedure applies to these errors.
Causes: • Imaging Unit, PL4.1.21 • Dispense Assembly, PL5.1.1 • Transfer Belt, PL6.1.7 • Toner Cartridge PL5.1.23 • MCU Board, PL10.7.7
Remedy: 1 Check the Magenta toner motor. Caution: Do not run the toner motor more than a few seconds.. Printer Diag > IOT Diag > Digital Output DO-23 Does the motor rotate? Go to step 2. Go to step 3. 2 Check the Dispense Assembly gears. Is the Magenta cartridge gear damaged? Replace the Dispense Assembly. Go to step 6. 3 Check P/J18 and P/J182 connections between the MCU Board and the Magenta toner motor. Are the connections secure? Go to step 4. Reseat the connectors. 4 Disconnet P/J18 and P/J182 and check the harness continuity. Is the harness damaged? Repair the harness. Go to step 5. 5 Check for +24 V at P/J18-8 of the MCU Board. Is 24 V available at pin 8? Replace the Dispense Assembly Replace the MCU Board. 6 Replace the Imaging Unit. Does the error persist? Go to step 7. Complete. 7 Reseast the Transfer Belt at the Front Cover. Does the error persist? Replace the Transfer Belt Complete