Code: 010-317
Description: Reseat Fuser Error Warning Allow the Fuser to cool before removal. The Fuser has failed. This troubleshooting procedure applies to this error.
Causes: • Fuser, PL6.1.1 • MCU Board, PL10.7.7 • Fuser Harness, PL10.8.6
Remedy: 1 Check the connectors P/J17 and P/J171 between the MCU Board and the Fuser. Are the connectors secure? Go to step 2. Reconnect the connectors. 2 Check the Fuser harness for continuity. • Disconnect P/J17 from the MCU Board. • Disconnect P/J171 from the Fuser. • Disconnect P/J47 from the LVPS. • Check continuity between P/J17 and P/J47 <=> P/J171. Is the harness damaged? Go to step 3. Repair the Fuser harness. 3 Check the Fuser temperature sensor resistance at these pins on the Fuser connector J171: • J171-5 <=> J171-4 • J171-6 <=> J171-8 • J171-6 <=> J171-7 Is there a measurable resistance between each pair of pins? Replace the MCU Board. Go to step 4. 4 Replace the Fuser. Does the error persist? NOTE Reset the Fuser life counter after installation of a new Fuser. Replace the MCU Board. Complete.