Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-372 — Xerox Phaser 6128 MFP

Code: 042-372

Description: K Mode Sol Error The K (Color) Mode Solenoid has failed. The following troubleshooting procedure applies to this error.
Causes: • Feed Drive Assembly, PL7.1.4 • MCU Board, PL10.7.7 • Registration (KSNR) Harness, PL10.8.9
Remedy: 1 Run the K Mode Solenoid test (DOa) on. Does the solenoid opearate? Go to step 2. Go to step 3. 2 Reseat the Feed Drive Assembly. Does the error persist? Go to step 6. Complete. 3 Check the solenoid connection. Is P/J24 on the MCU Board secure? Go to Step 4. Secure the connection. 4 Check for +24 V at J24 on the MCU Board. Is +24 V available at J24-1 <=> ground when the Interlock Switch is closed? Go to step 5. Replace the MCU Board. 5 Check the solenoid resistance. Is the resistance across J24-1 and J24-2 80 to 110 Ohms? Replace the MCU Board. Replace the Feed Drive Assembly. 6 Check the solenoid connection. Are P/J26 and P/J261 secure? Go to step 7. Secure the connections. 7 Check the Registration (KSNR) harness continuity. Disconnect P/J26 from the MCU Board and P/J261 from the solenoid. Is the harness damaged? Repair or replace the harness (PL10.8.9). Go to step 8. 8 Check for +3.3 V at J26 of the MCU Board. Is there +3.3 V between ground <=> J26-1 on the MCU Board when the Interlock Switch is closed? Go to step 9. Replace the MCU Board. 9 Run the K Mode Sensor test (DI-04) on. 1. Remove the Feed Drive Assembly leaving P/J261 and P/J24 connected. 2. Close the Front Cover. Does the display change when the sensor is blocked? Replace the MCU Board. Replace the Feed Drive Assembly.

← Xem tất cả mã lỗi Xerox Phaser 6128 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie