Code: 061-370
Description: Laser Error An error was detected in the Laser Unit. The following troubleshooting procedure applies to this error.
Causes: • Laser Unit, PL4.1.1 • ROS RE Harness, PL4.1.22 • ROS Video Harness, PL4.1.23 • MCU Board, PL10.7.7
Remedy: 1 Check the Laser Unit for correct installation. Is the Laser Unit correctly installed? Go to step 3. Reinstall the Laser Unit, then go to step 2. 2 Does the error still occur when the power is turned On? Go to step 3. Complete. 3 Check P/J40 and P/J41 on the MCU Board, and P/J411 and P/J412 on the laser Unit. Are the connections secure? Go to step 5 Reconnect the connections. Go to step 4. 4 Does the error still occur when the power is turned On? Go to step 5. Complete. 5 Check the ROS RE and ROS Video harnesses for continuity. Is the harness damaged? Repair the harness, then go to step 6. Go to step 7. 6 Does the error still occur when the power is turned On? Go to step 7. Complete. 7 Replace the Laser Unit. Does the error persist? Replace the MCU Board. Complete.